Host: No mostrado/ Not shown
IP: No mostrado/ Not shown
Sistema: Windows XP
Re: XbusTCO and NanoX-S88
Publicidad
Hallo!
>HI christoph ; > >the xbus tco is compatible with nanoxs88 ; verify your xpressnet adress on the dip switch, and is the number 6 dip is "on" (use with "lenz" mode ; the mode used with nanoxs88
My XpressNET address is set to 31 and the dip 6 is set to on. > >on normal run, all led are off ; on your situation, what is the status of your leds? "light" of "flash", > The Status of all leds is off until i switch a turnout to or or back to off, then LED1 is going to flash shortly.
>what system use you? for your tco? inter or 2 buttons by turnout? ; verify your program "hex" writting on your pic ; i dont think is the raison of non functionment. > I'm using the switch version, and as you can see, the TCO does work, if switched to address 5 on a lockmaus, but does not work on the NanoX neither on Address 5 nor aon address 31.
>i leave other persons on this forum for indicating other possibility.... > >Best regards > >Brickrennes > > > > >>Hello! >> >>Is it possible to run the XbusTCO with a NanoX-S88? >>It seems not to work, I've tried it with a Lokmaus >>and it runs perfect, but with a XbusTCO it does nothing. >> >>Is the XbusTCO designed to work also with the NanoX? >> >>Thank you for your Answer. >>Christoph
19/10/2009 00:06
Re: XbusTCO and NanoX-S88
